[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 10 Jun 2001, at 17:01, Joe Plowick III wrote: > Can some one tell me if I have my lines setup correctly? The instructions > aren't that clear, and I prefer pictures (which there aren't any in the > instructions). > http://www.ij.net/type3lvr/oil_lines.jpg This looks at least close. How does the crossbar and fan housing fit? That's the key. You may have to adjust the angular position of the 3 upper street elbows to get them to clear completely. Those elbows are the ones Berg sells, but I use 1 standard street elbow from the hardware store for one of those to give a better fit; the standard ones are longer in one dimension, and that is useful, I think for the middle elbow. IIRC the hose that comes out of the pump goes to the port that feeds the center of the filter. Often there is a cast in marking on the filter base saying "IN" at the right location. I have always found this confusing, too, since it's not clear which way the filter expects the oil to flow thru it, and, yes, it matters. > And where would this go? This has the larger thread same as the hose ends. > http://www.ij.net/type3lvr/extra_piece.jpg Looks to me like a fitting just in case you need to add another right angle bend at the end of one of your hoses. I see you got the pressure relief pump cover, too. That's a nice touch, especially for colder climates. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe