[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 18 Jan 2001, at 20:45, Russ Wolfe wrote: > > I had never noticed this before. I checked several references AND > > looked at a number of FI harnesses I have and this is what I find: > > It appears that #14 IS supposed to be there for 68-9 for all those > > cars which do NOT have the extra cold start valve installed. There > > is no wire #2 or #25 in any of my harnesses. > > > I just looked closer at mine, (just the ECU connector, and the wires > up to the grommet where it goes into the engine compartment). It too > does NOT have #2 or #25. I didn't pay any attention the first time. Russ, since yours has no #14 wire there, does it HAVE the extra cold start valve wiring? I have one 68-9 harness with the extra wiring for the CSV. This one has #14 empty, but my others (68-9, without CSV) have #14 wired from the pressure switch. My Bosch literature shows this wire here, but it does not show the wiring for the 68-9 harness with the CSV. My 70-1 harnesses seem to have no #14 wire, but the 72-3 years do. The documentation is confusing.... - Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe