[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
I'm a bit confused about these seals. I am wondering if my bonnet and boot seals are the correct type and if so whether they are installed correctly. They have a flat rectangular cross section base with a curved "blade" coming off one side at about 45 degrees. They were installed with the flat part glued to the vertical return on the body seam (so the flat part is perpendicular to the lid) with the blade part hanging down on the inside of the body seam (the hole side of the hatch). I think it would make more sense for the blade part to point outwards towards the edge of the lid with the flat part glued parallel between the hatch and the lid but then I think the seal would be too thin to seal at all. I can't find any close up pics of the correct installation- could someone check theirs and let me know which is right? Thanks Mark Seaton Newly obtained Orange and rust 73 fasty- London ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe