RE:[T3] fastback pop outs

[BOB2TYPE3S@aol.com]

 Heather, the fastback only gets the ONE seal per side. It has 4 little studs 
that go thru the weld seam in their reseceptive holes, then the nuts go on 
those studs to anchor the seal. The seal goes over that lip and hides the 
lip. There are 4 black metal caps per window that act as a bending point for 
the glass (rubber stiffeners). And the screws for the latch are larger than a 
bug popout. The easiest way to install them is with a helper, and partially 
assembled window-seal combination, start by geting the seal started, then 
chase the studs in place, then the nuts for the studs, then finish the seal, 
then attach the latch. I hope this helps you out.
 Bob 65 Notch S w/ sunroof & Sue 70 Fasty w/ popouts currently open to let in 
the air.  P.S. Only the Notch & Square use the outer seal with pinch welt 
combination.

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe