[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Dave Hall wrote: > VW Factory manual says:- > > 311 405 361A and 371A use an M8 x 40 bolt for the lower fastening and fit > up to chassis 273513, while the later ones 311 405 361B/371C use an M10 x > 40 bolt. I assume the curved groove to accept the bolt is a different > radius as a result. > > The earlier joints have a small groove about 1mm wide around the adjusting > part at the bottom, but obviously not on the flats themselves! This may > not be reproduced in non-genuine،ـصنints, I suppose. My four non-genuine balljoints have no small groove and the curved groove seem to fit a M10 bolt very well. Conclusion: I have the wrong balljoints! Thanks to Dave and Jim for the information! Henrik Larsson, Sweden 1964 1500S Notch ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe