Re: [T3] Factory 27mm wrench

["Dave Hall" <dave@hallvw.clara.co.uk>]

Generator end clamping plate was my guess when you first mentioned the
tool; I have a similar one which came with a '64 Squareback in its original
cloth tool roll.
It isn't likely to be a front wheel bearing wrench as that would have been
the same as the early beetles too, so it would not be called a Type 3 tool.

Yes, just checked the tool-kit in the car;
"27  DIN 894" one side;  "27   Hazet, Germany" on the other.  Question
answered.

Dave.
UK VW Type 3&4 Club
http://www.hallvw.clara.net/
----- Original Message -----
From: Everett Barnes <everettb@prodigy.net>
To: Type 3 List <type3@vwtype3.org>; Greg Merritt <gregm@vwtype3.org>
Sent: 25 July 1999 20:18
Subject: Re: [T3] Factory 27mm wrench


> > What component(s) does this wrench fit?  Is it for the generator
> >pulley?  It's too small for the exhaust, right?



-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe