[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 5 Sep 98, at 18:18, Sonny8oy@aol.com wrote:
> i'm going to adjust my valves tomorrow ('69 FI, AT, stock orig. dist.).
> bentley says set the rotor to line up with the mark on the distributor; this
> is the tiny notch cut in the top of the lip of the distributor, correct?
> then i should mark where 90, 180 and 270ΕΊ are on the lip for cyls 2, 3, and 4?
> easy as that?
The mark on the dist is just approximate. That will get you started
on cylinder 1, which will be followed by 4,3,2 in the firing order.
What you should really go by is the TDC mark on the pulley for
cylinders 1 & 3 and the similar casting shape that is 180 deg away on
the pulley for 2 & 4.
Jim
-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************
-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subjbscribe