[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Jim Adney wrote: Pertronics supplies an adaptor plate with their unit which allows it > to adapt to the Bosch distributor. If you look at the outer edge of > this plate you will find a semi-circular cutout that is there to > clear a bent over tab that is part of the Bosch breaker plate. > The back side of the Pertronics unit itself was too close to one of > the mounting tabs for the breaker plate. I had to file part of the > black plastic away to provide clearance. > I have noticed this problem also..... I had to do these modifications to get a pertronics to work in my friends bus........ > The main problem is that the module is just a bit too large to fit > easily into the Bosch distributor. There is probably no good reason > why it couldn't be 40% smaller, but the design is done there is a new module out that is being sold for use in 009s ...... it is about half the size of the original..... -- the 009s had a problem with clearance of the rotor and the module..... I have compared the larger pertronics and the smaller 009 version... and I see no reason why the smaller version could not be used in other distributors...... Todd Daley 71 squareback ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe