<x-flowed>At 06:41 PM 5/18/2011, Dave P. wrote:
Anyhow; Isn't what David Y. is explaining here (valves going so far out of adjustment so quickly) a scenario that one would see when the head studs are slowly pulling out of the block?
The #1/#2 head hasn't been pulled or inspected so far, so this is a possibility, but the studs were tight on the #3/#4 side where the pushrod bent (and then torqued correctly when the head was put back on... and the problem persist) so I assume the pulling would then be happening on both sides. I dropped it off today and work begins tomorrow AM, so I'll call and ask them to double check this first.
David Y.; do you have case savers installed in this block?
I can't imagine the builder doesn't religiously use them, but I'm not %100 sure. I'll add that to tomorrow's "to do" checklist. Thanks!
Dave Y.
_______________________________________________ VWType3.Org mailing list - type3@vwtype3.org http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org Contact gregm@vwtype3.org if you need help with the list. </x-flowed>