Re: [T3] rear axle nut

["Jim Adney" <jadney@vwtype3.org>]

On 10 Aug 2011 at 18:40, crash 69 wrote:

> 1.14 x 12" = 13.7, or about 14" out.  Makes sense?  I presume "no bouncing",
> because that would add torque.

Exactly right. Measure from the drive center outward, then wrap a bit 
of tape around that spot so you know where to put your foot. Apply 
your weight with the bar horizontal.

Once you're there, check the alignment of the holes and then tighten 
more if necessary to align one set of holes. Use a standard cotter 
pin.

-- 
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

_______________________________________________
VWType3.Org mailing list - type3@vwtype3.org
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
Contact gregm@vwtype3.org if you need help with the list.