Re: [T3] Can't get dwell below 60

[Know One <knowonelse@sbcglobal.net>]

> Either the rubbing block on your points set is worn
> out, or you're doing something wrong.

It could be that the rubbing block is split. It looks
fine visually, and adjusts fine statically, but once
the shaft moves, the split appears and the block ends
up closer than adjusted messing the dwell.

Take the points out and look very closely at the block
to see if it is split.

Jeff  '67  Sqbk

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~