Re: [T3] Pan Gasket

["Sander Hessels" <shessels@kpnplanet.nl>]

<x-flowed>If I understand correctly, you are changing the gasket under the black 
rocker-covers on each side off the engine. There are complete gaskets for 
these covers made out off cork(?). They're included in an engine gasket set 
from most suppliers!


Sander Hessels

Kerkweg 11
1761 JD  Anna Paulowna
0223-693994
06-42901253

http://www.sander-hessels.nl
http://clik.to/beestenboel/

----- Original Message ----- 
From: "Keith Park" <topnotch@nycap.rr.com>
To: <type3@vwtype3.org>
Sent: Sunday, September 10, 2006 2:14 AM
Subject: [T3] Pan Gasket


> Pan gasket question,
>
> I bought a length of new gasket for the rocker section I replaced on the
> rocker. However, this stuff doesn't bend around curves.  I though of 
> cutting
> out pie shaped sections but didn't have any warm and fuzzy doing that,  I
> ended up using a used section of seal that was in great shape but What to
> folks do to get the new straight gaskets to get around the curves???
>
> Keith
>
>
> Top Notch Restorations
> topnotch@nycap.rr.com
> 71 Squareback
> 65 Notchback "El Baja Rojo"
> 65 Squareback "Eggcrate"
> 87 golf "Winterat"
> 93 RX7 "Redstur"
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.12.2/442 - Release Date: 8-9-2006

--------------------------------------------------------------------------------
Mijn Postvak In wordt beschermd door SPAMfighter
588 spam-mails zijn er tot op heden geblokkeerd.
Download de gratis SPAMfighter vandaag nog! 

</x-flowed>