[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
> check the pedal free play. After reading the Bentley, it says you need 8"
> of travel between the pedal and the cross piece, and 4-7mm of pedal free
There should be a little bit, like 1mm free between the end of the rod and
the pedal when it is fully released.
That is to make sure the MC 'is' fully released.
i just looked at the bentley.
the 4-7mm is free travel at the footpad of the pedal and the 8in
is how much travel from the pedal to the floor. I think you can just
ignore those measurements unless the pedal has been screwed around with.
Just set the pedal so there is a small but definate gap between the
pushrod and the pedal when its fully up. like it says 1mm.
on a bus you change the length of the pushrod to do it, on a type3 you
move the pedal. same adjustment.
__________________________________________________________________________
andy miami fl
64 'lenore' 68 'slowpoke' daughters 71 squareback (nameless)
T2 buy/sell babysitter
www.type2.com/~andy
__________________________________________________________________________
ICQ 109998779 AIM - bulli64
__________________________________________________________________________
Philosopy of Leswests
* We like to enjoy the good things in life.
* We are in favor of activities which don't cost much.
* We prefer to camp outside of campings,even if it's not too legal.
* We don't bother much about keeping our West's as neet or closer as
possible to the original look of a Westfalias, we prefer the
utility and the personnality of the vehicule.
* We try to repair ourselves our Wests.
* We try to help each other at the most.
* We wanna have fun!
_________________________________________________________________________
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~