[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Fri, 2006-06-02 at 21:11, Keith Park wrote: > That's it. The Square cut one. > The Ball bearing (#6) sure looks like it comes right out after removing that > C clip, Remind me why I cant just pop it out and replace it? It even feels > loose in the case. > You can't just pull it and replace it, because the shift forks need to be adjusted so the gears engage completely, with no load on the forks after it is in each gear. And this has to be done as it would be in actual use. There are some expensive fixturing, that simulates the case but gives access to the fork adjustments, and gives you the ability to turn the trans by hand while doing this. -- Russ Wolfe '71 FB AT '66 FB MT '64 T34 (not running) '65 T1 (not running) '05 KIA Sorento SUV russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~