Re: [T3] Radius Arm

["Mike Fisher" <fisherfarms@uwol.net>]

<x-flowed>I've got the radius arm free from the axle but have only about 3/16" gap so 
far prying with a crow bar.  The arm is resting on the ledge still.  I tried 
lifting ARM with jack to get it off the ledge but didn't have much better 
luck prying that way.  Should I try hammering on the backside of the ARM? 
Is a crowbar the only possible tool used to separate the radius arm from the 
torsion bar?  Mike
----- Original Message ----- 
From: "Dave Hall" <dave@hallvw.clara.co.uk>
To: <type3@vwtype3.org>
Sent: Monday, August 07, 2006 11:16 AM
Subject: Re: [T3] Radius Arm


> Well done.  It's the sort of place a Dremel type of tool can get into 
> without
> too much damage, but you did well with a grinder.
>
> Dave.
> UK VW Type 3 & 4 Club
> http://www.hallvw.clara.co.uk/
> ------
> ----- Original Message ----- 
> From: "Mike Fisher" <fisherfarms@uwol.net>
> To: <type3@vwtype3.org>
> Sent: Monday, August 07, 2006 6:26 PM
> Subject: Re: [T3] Radius Arm
>
>
> > I ground off the nut and saved enough stud to hold a new nut!
> > ----- Original Message ----- 
> > From: "Mike Fisher" <fisherfarms@uwol.net>
> > To: <type3@vwtype3.org>
> > Sent: Monday, August 07, 2006 6:56 AM
> > Subject: Re: [T3] Radius Arm
> >
> >
> > > Thanks Dave.  That gives me the courage to get out the grinder!  I'll
> > > probably burn my sea-sand paint but it all has go anyway.
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.10.7/411 - Release Date: 8/7/2006


</x-flowed>