Re: [T3] Clutch Operating Shaft Oddities

[The Canadian <cndt3@shaw.ca>]

Thanks Jim.  I had removed the screw but now I see what I did wrong.  I
should not have removed (slid over actually) the circlip on the inside of
the housing as this is what 'pulls' the sleeve out when the shaft is pulled
to the left.  The sleeve was simply stuck in the tranny housing and I was
sliding the shaft back and forth inside of it.  No oddities after all, just
my usual bungling!

Andre


> To get things apart, look on the outside of the tranny case, just in
> front (front is front) of where the clutch shaft passes into the
> case. You will see a 10mm hex head there. Unscrew and remove it. Now
> the bushing will slide out.  When you reinstall it, make sure that
> you get the hole in the bushing pointing toward that bolt hole so
> that the fixing bolt drops into it without damaging the bushing.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~