[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Mon, 2005-05-30 at 23:13, Constantino Tobio wrote: > Looking at my Bentley, it would seem that one needn't necessarily remove > the governor to remove the governor cover. Right? How would I keep this > governor from falling out? Is there a trick, or will it not fall out if > you don't screw with it? > > My tranny has a little bit of grease covering it. I'm probably going to > degrease it when I get a chance (after I change out the ATF) to see if > there's a real leak or just decades of accumulated minor seepage. > The governor won't fall out when you pull the cover. It is horizontal. Just don't pull it out to replace the o'ring seal. leave it in place. Daniel was lucky. Usually that square drive piece drops down into the differential. Then you have to go fishing with a magnet in the differential to get it out. -- Russ Wolfe '71 FB AT '66 FB MT '64 T34 (not running) '65 T1 (not running) '05 KIA Sorento SUV russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~