[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Today's work


On 10 May 2005 at 15:36, Daniel Baum wrote:

>  - I have installed a new set of plug wires. The dizzy to coil wire in the 
> set was too short, so rather than using the red wire from my previous set I 
> resurrected a black one from the set the car had when I first got it. It 
> looks OK visually, and shows 0 resistance. How else can I check that it's 
> OK? This old set, I believe, has original Bosch plug connecters, so I might 
> reuse them some day.

I'm not sure whether your engine would have come with the right angle dist cap 
connectors or not. They were standard on all the FI engines because the dist 
was taller on those and the taller dist combined with straight connectors 
caused the wires to rub thru the engine lid insulation and eventually thru the 
SP wire rubber. This is still something to watch out for.

The coil wire should be fine as long as the insulation is sound.

The Bosch SP connectors can be reused on any 7mm SP wire. They just screw in, 
so you can simply unscrew them from the old wire. The connectors themselves 
should measure ~1000 Ohms.

One of the BIG advantages of the OG right angle connectors is that they also 
just screw onto the SP wire. This means that it is easy to just buy bulk wire 
and replace it and adjust the lengths easily for a perfect fit.

I see that you are missing some of the fittings that make for dressing the SP 
wires neatly. There is a hole in the rear face of the right upper shroud that 
should have a plastic clip to hold those 2 wires. There should be a bracket 
that holds the left wires that bolts to one of the holes on top of the left 
upper shroud. None of these are critical, but they would neaten up the wires.

> - I now have everything put together except the exhaust, which I'll do when 
> I feel like abusing myself :~)

The exhaust really isn't bad to deal with, except for freeing up the upper heat 
exchangers from a perished muffler.

-- 
Jim Adney
jadney@vwtype3.org
Madison, WI 53711-3054
USA

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]