[T3] SWingaxle wheel bearing seals.

[John Jaranson <jaransonT3@comcast.net>]

<x-flowed>I am putting Sophy's rear end back together and the seal/gasket sets 
that I picked up for the wheel end of the swingaxle tubes each have two 
(2) paper gaskets in the kit.  All the pictures in my Bentley and 
Haynes show a single paper gasket between the bearing cover and the 
backing plate.  Along with the o-rings and other bits in there.

Where does the second paper gasket go?

 They are identical.  Someone suggested that it goes between the 
backing plate the the axle tube, but the large central hole isn't big 
enough to go there.  Is this a Type 3 vs. Type 1 thing?

Trying to get this together tonight so any help would be appreciated.

Thanks.

Later,
John Jaranson
'66 Square (Sophy)
'71 Fasty (Jane - darkside project in waiting)
various parts.....don't we all.
http://mywebpages.comcast.net/jaransonT3/jaransonT3/
http://mywebpages.comcast.net/jaransonT3/2006Invasion/
http://mywebpages.comcast.net/jaransonT3/notavwclub/

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

</x-flowed>