[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 19 Mar 2004 at 19:41, Russ Wolfe wrote: > On Fri, 2004-03-19 at 19:25, Jim Adney wrote: > > Too bad you didn't mention this earlier. We use lots of phenolic here and > > there's always scrap avalable. What thickness are you using? Could you use any > > more? > > Bob said his were 8mm thick with the gaskets. So I got 1/4" Garloc. It > is good up to 285F. > Yeah, I could probably use more if you have some. I will probably screw > up a few. ;=) I will probably start with 3"x3" pieces for the mill. 5/16" would be perfect, but I don't know if it comes in that size normally. We probably have some 1/4" scrap, I'll check on it. I've got your address. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org