[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
At 08:59 PM 6/20/04, Jim Adney wrote: >On 20 Jun 2004 at 21:42, BOB2TYPE3S@aol.com wrote: >> You're going to need about 25 feet to do a FI car. >I think it's more like half that, just because the long runs from front to rear >are all done in steel tube. Nah, 25 feet is pretty close, and better to have more hose than not enough. We did the job on a '69 Square at the DDB's shop, and used about 19 feet. All the lines under the tank (including the little loop to that dampner thing), the two that run from the pan to the engine, and the ring main loop. It would have taken more if the car was a later one with the coldstart valve. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org