[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 19 Jun 2004 at 16:24, daveb wrote: > Currently my car has no seat belts installed and it appears to have only > provisions for a shoulder harness. I have a pair of aftermarket (empi) lap > belts and am wondering how to install them? I'm guessing I could drill > through the vertical wall of the pan in front of the rear seat for the outer > attach point, but is that strong enough? Then, what about attachment to the > center channel? The threaded holes are about 1" diameter. You'll have to drill and reinforce the outside lower hole. I believe there are adaptors for the early 1" holes to take the late 7/16" attachment bolts, which I believe were 11 tpi. Yes, 7/16", really! -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org