[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
> > boxes have 2 new numbers, 361 821 715A and 361 821 705. I did however > take > > the fenders off my 65 notch to have a look at the beading . Well there is > > only 4 pieces, no short pieces. But while the new fronts seem to fit the > > rears aren't close. They are way too short. The Notch rear fender beading has a dip down and change to round section where the decklid comes, and goes down to the bottom - that's why it is longer. The Fastback and Squareback only goes as far back as the top of the tail-light assembly; another (much wider) piece does the rear apron to underside. The -705 should be front left early (now listed as -705A). I think the only difference from the right side is that the rear end is trimmed at the opposite angle, to match the front fender line. Anyone else confirm this? Generally there is enough stretch in a new beading to be cut the opposite way if needed - put it in hot water or do it on a warm day. Dave. UK VW Type 3 & 4 Club http://www.hallvw.clara.co.uk/ ------ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org