[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
>Caster is set by the rubber axle mounts (not too easy to adjust). >Camber (the lean of the wheel from the vertical) is adjusted by the upper >ball-joint (the bottom part of the tapered rod with flats for a wrench). Ê It's the flats for the wrench that I was trying to express in my crude drawing... >The >notch on the bottom suspension ball-joints should face forward - worth checking >before aligning! These new production ball joints had no notch, or mark of any sort. Nor did they have zerk fittings, which I find annoying.. >I assume these are degrees? Ê1.3deg +/- 0.3 (max difference 0.3 deg) is the book >figure for camber. Yeah, all my stated figures were in degrees. What adverse affects would occur if I happened to install these ball joints out of whack (no notch forward). Would this affect my geometery? I suppose it's getting close to trial & error at this point... *groan* ;~) Cheers, Curtis C.Rochambeau 327/1600 http://binauralaboratories.net ~electronic manipulation's our specialty~ ---------- Original Message ----------- From: type3-d-request@vwtype3.org To: type3-d@vwtype3.org Sent: Fri, 27 Jun 2003 17:59:44 -0700 (PDT) Subject: type3-d Digest V2003 #232 > type3-d Digest Volume 2003 : Issue 232 > > Today's Topics: > Re: [T3] Unsub. for the weekend, bac [ Per Lindgren <lindgre@online.no> ] > RE: [T3] FI Connector inserts... any [ "Kevin Guarnotta" <kguarnotta@usa.n ] > RE: [T3] the friendly list (was valv [ "Kevin Guarnotta" <kguarnotta@usa.n ] > [T3] regarding location.... [ "Kevin Guarnotta" <kguarnotta@usa.n ] > RE: [T3] the friendly list (was valv [ "Kevin Guarnotta" <kguarnotta@usa.n ] > Re: [T3] dizzy/carbs/timing [ "Shad Laws" <shad@lnengineering.com ] > RE: [T3] the friendly list (was valv [ "Roush, Norman" <norman.roush@hp.co ] > [T3] Looking for a local mechanic [ TITEOCALLI@aol.com ] > RE: [T3] the friendly list (was valv [ Greg Merritt <gregm@vwtype3.org> ] > [T3] Tec Shop - Seattle [ "Molleston" <mollestonfamily@prodig ] > Re: Front Beam [T3] [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] the friendly list (was valv [ Brian <vwfye@frontiernet.net> ] > Re: [T3] the friendly list (was valv [ Greg Merritt <gregm@vwtype3.org> ] > [T3] Fuel line and other oddities [ Aaron Clow <vw_variant71@yahoo.com> ] > Re: [T3] FS- RHD Dash top [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Fuel injectors -- is this s [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] fuses [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Fuel injectors -- is this s [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Fuel leak [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Fuel injector leaks [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Coil wire [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] dizzy/carbs/timing [ "Dave Hall" <dave@hallvw.clara.co.u ] > Re: [T3] Coil wire [ "Gary Gamboa" <gary_gamboa@hotmail. ] ------- End of Original Message ------- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org