[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
I tried my local VW dealer-they said it is NLA. Then I tried F*reign Aut* P*rts-they said try JC Whitn*y, then my local FLAPS-all said no. I have done a quick search of the internet, and can't seem to find something like this...anyone have any ideas of another source? If you have some Jim, I would be looking for two-I imagine I should replace both of them while I am at it. But if the one on the driver's side looks good, I can keep using it. Can you include those with the distributor you send, let me know how much. Thanks -kevin somerville, ma '65 kombi '71 sqbk -----Original Message----- From: Jim Adney [mailto:jadney@vwtype3.org] Sent: Thursday, June 12, 2003 12:52 AM To: Type 3 List Subject: Re: [T3] exhaust gaskets On 11 Jun 2003 at 20:18, Kevin Guarnotta wrote: > on my squareback I think I need to change the gasket/seal between the > muffler adn the rear heat exchanger. In the bentley manual page 10 in the > engine section is a diagram of this...it is part # 47. Seal, 36x42 It's a copper over fiber O-ring, ID & OD, # N 138 361. Have you tried your VW dealer? They may still be available. If not, I may still have some. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org