[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
I finally finished my transistorized ignition module that I ordered from Vellerman Electronics. Because I'm going to install it in the engine compartment I want to seal the components from the elements. The module is built into a small plastic box with cut outs for the heat sink to poke through. I was wondering if I could just fill or just coat the the circuit board and its components with epoxy? I figured I could use a bit of the epoxy that I bout to make my door panels. Thorkhild Darkside Apprentice 68 VW Blue Fasty http://www.geocities.com/vwbluefasty/ New Washington based Type 3 Club http://www.aircooledkings.com/modules.php?op=modload&name=PNphpBB2&file= viewforum&f=6&sid=98d24948062d9cdee1b5b5644b4604c2 ------------------------------------------------------------------- List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org