[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 18 Aug 2003 at 18:18, Jacob Schroeder wrote: > I'm installing the headliner for my '72 Square and I'm having a hard time > figuring out what to do in the rear corners of the car... it looks like the > headliner is supposed to tuck under this little metal flap, and then the > flap is supposed to clamp down on the headliner. Is this right? The original piece here had a special plastic hooked rib molded onto the headliner material. This is just a small triangle of headliner stuff with about 10" of the white rib attached. > I need some advice here as that metal flap doesn't seem very pliable at all > and it is quite shallow, so it's not like I can tuck an inch of headliner in > there then clamp it down, any suggestions would be greatly welcomed at this > point, thanks, Yes, the metal is too stiff to bend and was not intended to. If you don't have the original parts you will probably have to wrap the headliner material in there and glue it into position. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org