Re: [T3] Removing heat exchangers

["Dave Hall" <dave@hallvw.clara.co.uk>]

Typo in last mailing - 46mm nut on heat exchangers and most bus rear axle
nuts.  That would be 1 13/16" I expect in the USA!

Dave.
UK VW Type 3 & 4 Club
http://www.hallvw.clara.co.uk/
------
----- Original Message -----
From: "Dave Hall" <dave@hallvw.clara.co.uk>
To: <type3@vwtype3.org>
Sent: Wednesday, October 23, 2002 3:32 PM
Subject: Re: [T3] Removing heat exchangers


> Lots of heat is the only way I've heard, but usually of course you cut the
> muffler off so the nuts can be tackled using a Bus 45mm socket.  The
> open-ended version isn't always up to undoing really, but is helpful to
> tighten after aligning on the car.  Undo them before the car has been left
> too long!
>
> Dave.
> UK VW Type 3 & 4 Club
> http://www.hallvw.clara.co.uk/
> ------



------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/