[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
on 16/10/2002 8:38 PM, Freddie Lochner at 69notch@aircooled.net wrote: > Could very well be a loose bearing set... > > Or worn out tie rod end(s) - especially check driver's side inner, as it is > different from > the other three, harder to find a replacement for, and therefore not likely > replaced > when/if the others were. > > Good luck. Oh, I don't know enough about the anti-roll bar to say. OK, I will have a look this weekend- I am going to re-adjust the height on the left side, it is sitting a bit lower than the other side, and it is more noticeable with the new wheels. How do I check for loose bearings? Thanks, Ben Doughney '75 1200L '63 1200 - Ringo '71 1600TL http://members.tripod.com/~superkafer/ ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/