[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset iso-8859-1>I wouldnt use an air chisel... a cutoff grinder would be better. Theres your outer cover, inner sheath, air tube and perhaps another layer. I could take a pix of the one on my 65 as its rusted through EACH of these layers but its different than the late ones. Id be careful of what I cut through. I do have a cross section picture of a late door piller. Keith Keith Park Top Notch Restorations topnotch@nycap.rr.com 71 Squareback 65 Notchback 65 Squareback 75 Opel 87 Golf 88 Rx7 10th Anniversary ----- Original Message ----- From: "Rainman" <rainman@friendlynet.com> To: <type3@vwtype3.org> Sent: Saturday, June 22, 2002 10:40 PM Subject: [T3] Need rocker panel help > Ok, I tried to follow the exploded views thread but it never gave me what I > need...so, here goes...i want to repair the inside of my rocker panel. It > has about 8 small holes in it and I would like to repair it from the inside. > What is in there...i want to use an air chisel and cut out the top section > on the door sill (that will be covered by sill plates later). Does anyone > have pictures of the inside (drivers side) or a nice hi res drawings? I > want to see what to avoid when I cut in. > > TIA, > > ray > > > ------------------------------------------------ > To unsubscribe, E-mail to: <type3-off@vwtype3.org> > For more help, see http://vwtype3.org/list/ > ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/ </x-charset>