[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset iso-8859-1>hello all, I am having a problem with my Brothers fasty. it keeps acting like it is missing in the 1 and 2 cylinder.. It is a 1600 with dual carbs. ,points, plugs, plug wires,cap, rotor, timing are all good and set correct. I have the idle screws set 1/2 turn in and the volume screws set 1 1/2 turns out. when it started doing this we would replace or reset something like the points or plugs or timing and it would idle good, then we would take it for a test drive and it would do well at first for about 20 seconds and then it would lose power and start chugging. when you rev it and pull a right side plug from the distributor it doesn't seem to change the way the motor runs. I am at a loss here, I am gonna pull the top off of the carb to see if the float is stuck , any advice is appreciated, thanks in advance, Bryan ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/ </x-charset>