<x-flowed>Yes, the timing used to be way too advanced. I fixed that problem about a year ago. I replaced the voltage regulator a few years ago. It still reads around 14 volts at medium rpm. The reason I think that it's getting too much gas, is because it gets terrible mileage. Stunk like unburned fuel when I was trying to start it. I had to hold the throttle wide open for it to start, and then keep the rpms up to keep it alive. If I understand the way the throttle position sensor works, when you depress the pedal it sends a signal to tell the injectors to squirt extra fuel. When I would depress the pedal quickly, it would almost kill the engine. The auxiliary fuel injector in the air distributor has been disconnected for years, so that's not the problem. I still don't have a pressure tester for the fuel system, but I have always assumed that if anything it is too high, just because of my poor mileage. I had a ripped apart intake belows, so I recently replaced that. It is sealing well now. All of the engine tin is there and in place. The spark plug boots are there, but they are hard, and don't seal extremely well. I just adjusted the valves to .006" on intake and exhaust at the last oil change. I just replaced the vacuum advance on the distributor last month. The mechanical advance seemed to work smoothly, too. (turning it by hand and letting it spring back) I have it timed at 0¡ right now. That's what it should be for a '71, I beleive. It does advance smoothly when revved. Right now I feel very betrayed by my car. I just spent several hours last night washing and waxing it. This is how it repays me.
Jacob Hoffman '71 FI AT Squareback '76 Westfalia "at least it runs well" bus
From: Jim Adney <jadney@vwtype3.org> Getting too much gas would make it run cool, not hot, so I'm not sure where your problem really is.Start with the basics: Is all your cooling tin there? Are the spark plug airseals in place? Is the cooling air intake bellows secured at both ends and intact? Then how about the timing and valve adjustment? Is the mech. advance working smoothly? There is probably more than one thing wrong with this car, so you need to check out several things. Make sure that the charging system regulating voltage lets the system voltage get up to 14 or so volts at med RPM and above. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA *******************************
_________________________________________________________________Join the worldâs largest e-mail service with MSN Hotmail. http://www.hotmail.com
------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/ </x-flowed>