[T3] SO close....

["Hugh Lawrence" <localman26@hotmail.com>]

<x-flowed>

My car has been out of commission for a while and now I think it is pretty 
much ready to run (I dropped the engine to re-grommit the oil cooler as some 
might recall, and had to de-rust my tank). However, the cold start stuff is 
not hooked up and I am starting to think that I need it (I have a '72 where 
it is more critical than pre-70). I am confused whether the switch under the 
IAD (and on the left) is the thermo switch or it is for the backup lights. 
Bentley says the thermo switch should be on the right side. There is no 
switch on the right side near the IAD that I can see. Did I manage to lose a 
car part? It's all very confusing, and I am anxious to figure it out as I 
would like to show it off on Christmas. I have a 1.5 foot long wire (1.5 
awg?) lying around that has single wire slip-on connectors on both sides and 
a 4-inch long wire protruding from one end that ends in a smaller single 
wire connector. Is this wire supposed to connect the thermo switch to 
something next to the cold start valve? And, if so, where does the switch 
get power *from* (where it grounds to is obvious).




_________________________________________________________________
MSN 8: advanced junk mail protection and 3 months FREE*. 
http://join.msn.com/?page=features/junkmail&xAPID=42&PS=47575&PI=7324&DI=7474&SU= 
http://www.hotmail.msn.com/cgi-bin/getmsg&HL=1216hotmailtaglines_advancedjmf_3mf


------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/
</x-flowed>