Re: [T3] keith, don't look... (solid rocker shafts)

[Jim Adney <jadney@vwtype3.org>]

On 3 Dec 2002 at 20:13, Magnia, Martin wrote:

> I have a set of Autocraft solid rocker shafts and the entire thing is cast
> as one part, the divider is solid and doesn't move. You would add a few
> needed spacers to it then the rocker and so one. I can see if this section
> did move as a problem but if it is solid then it poses no problems.

So your shaft and "spacer" is machined from a single solid piece? This sounds 
like the right way to do it. I doubt if it is cast, however; if it is, then 
that's probably a different kind of problem.
-- 
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************


------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/