[T3] adjusting the Torsion Bars

[<veedub@apartment101.com>]

<x-charset iso-8859-1>My 68 Notch was lowered by her previous owner.  Is there a way to determine
what the factory settings were so that I can raise her from the "dark side"
back to a more factory-like ride?

I think in the process of lowering her, the previous owner did not match the
torsion bar notches appropriately, as she sits about an inch lower in the
left rear side.

You can see how much she's been lowered in this pic at
http://www.apartment101.com/uploads/68Notch_rear.jpg  It looks as though
she's been lowered more in the rear than in the front, but she has
P205/65R15's on the rear (they don't rub beleive it or not - but its close)

Any suggestions you could give me would help.  I couldn't find the settings
in my Bentley, but maybe I wasn't looking in the right place.

Jason
68 Notch









-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe

</x-charset>