[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
With all the recent discussion about crankshaft end play, I want to make sure that I get this right. I just measured the endplay on my 66 1600 and it is .008" - a bit outside the spec of .0028 - .005". If I understand my Bently manual right I can add a thicker shim to get it into spec, assuming of course that I don't already have the thickest shims in there. Is this right? I am going to pull the flywheel again and check the thickness of the shims that are in there now. I will figure out what I need for additional thickness. Can I use the shims that are in my 71 1600 Automatic motor for now. I don't have anyu other shims around and I only have the dial indicator for tonight. Thanks for the help.... John Jaranson '71 FI Auto Fasty (Jane) '66 Square (???) http://hometown.aol.com/jaransonT3 ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe