[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [T3] sync carbs
- To: "type3" <type3@vwtype3.org>
- Subject: Re: [T3] sync carbs
- From: "Russ Wolfe" <russella@prairieinet.net>
- Date: Tue, 13 Mar 2001 16:55:47 -0600
- References: <004701c0ab73$44b56060$0400a8c0@wyrless.net> <3AAE0C1A.3493.5CEB3090@localhost>
- Resent-date: Tue, 13 Mar 2001 20:37:05 -0500
- Resent-from: type3@vwtype3.org
- Resent-message-id: <"h80-6.0.y43._iihw"@maria.yourwebhost.com>
- Resent-sender: type3-request@vwtype3.org
Subject: Re: [T3] sync carbs
> On 13 Mar 2001, at 9:39, Hal Sullivan wrote:
>
> >
>
> Russ: When you did this for a living, did you usually just eyeball it?
> Did you EVER use the special factory tool?
>
> I've never seen this tool, only pictures, but I've always thought
> about making one from a spring-loaded clothespin.
>
> -
If the tool was handy, or it was a problem car, I used the tool. We only had
2 of them in the shop, so you had to figure out who had used them last. I
always meant to buy one, but never did.
I think a person could make one with a snapping clothes pin without too much
trouble, if you had seen one, or had seen a picture. Just remember to
include the offset to allow for the thickness of the material you use.
Russ Wolfe
russw@classicvw.org
http://www.classicvw.org/
-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe