[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 7 Jan 2001, at 3:21, LOW40hpVW@aol.com wrote: > Also.. im hooking up the shift cable. I have the shifter in park. So > i put the tranny the switch on the side all the way the the back of > the vehicle as it will shift. then tighten the little barrel nut > deal... 1. Which side of the shaft/switch does the cable ride on? > Closer to the inside of the transmission or on the outside of the > switch? and 2. When i have it tightened down. i pull it down into > gear Say all the way down to First. ok nothing binding everything > cool shifts transmission into first then i go back to park and the > switch on the side of the tranny doesn't move it doesn't want to > return to gear. is there a Spring or anything to return the > transmission? am i missing something? or does it need to be full of > fluid to operate or what is the deal?!??? There are good pictures and instructions in the Bentley manual, page 8/46. A good picture is worth 1000 words and this is one of those times. Among other things it shows the inner wire secured to the inner face of the AT selector lever. Is it possible that you don't have the cable housing anchor bracket? Both the inner wire and the outer housing must be secured on BOTH ends of the cable. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe