[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
I have 40 Dells on my 90.5x78 with an engle 125 (301ยก) cam. 40x35.5 heads with worked ports and 3 angle valve job. No problems at all. Certainly doesn't run out of breath!! It's the venturi size that matters more than the throttle bore. Mine have 34mm venturii. Hope this helps! Gary Miller UK -----Original Message----- From: Seth [mailto:KTrout2@lvcm.com] Sent: 02 February 2001 00:42 To: type3@vwtype3.org Subject: [T3] carb size question (stroker) Im ordering the heads, crank, and rods tomorrow----- i already have a nice set of 40 dells (thanks to kinny, if you are reading this).......im thinking of going 74 by 94, is this enough carb for this size motor or should i stick with 74 by 90.5?? id really like the larger crank or should i forget about it with these sized carbs?? also im going with the CB's 044 magnum plus's, the only difference between those and the competition heads is the 3 angle valve job, although your sacrificing the full port and polish along with price difference, even though u can add on the port and polish on the competitions for another hundred, to get to the point here, what benefits are their from a 3 angle valve job?? thanks Seth ----- Original Message ----- From: <type3-d-request@vwtype3.org> To: <type3-d@vwtype3.org> Sent: Thursday, February 01, 2001 3:46 PM Subject: type3-d Digest V01 #68 ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe