Re: [T3] Gauges

["Jim Adney" <jadney@vwtype3.org>]

On 29 Aug 2001, at 17:43, Joe Plowick III wrote:

> Where would I mount an oil temp sensor?  I was going to Tee off the
> stock location for the stock sender and oil temp.  Is there a better
> place?

There are places that sell them in the form of replacement plugs for 
the oil pressure relief valves in the bottom of the case. This is 
probably the best place. If the sensor was on a rather long probe, I 
always thought that stuck down in the oil cooler would be good: If 
you could stick it thru a street tee then you could put the OE 
pressure switch on the branch of the tee, but the temp sensor 
would have to be long enough to actually reach down into the body 
of the cooler.

-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe