[T3] engine installation

[Brian Van <bvand1000@yahoo.com>]

I finally got it in.  It turns out that the splines in
the new friction plate just barely didn't go through
to the transmission side, thats why no amount of
rocking or pushing would make it go.  I took it out,
turned it around and tapped it onto the tansmission
shaft backwards, which loosened the splines up a
little.  Then the engine went in no problem.  The new
clutch works, but i forgot the shift rod coupler, so I
won't get to test drive it until tomorrow.  Thanks to
everyone for your help.

Brian
'63 Notch 

__________________________________________________
Do You Yahoo!?
Send instant messages & get email alerts with Yahoo! Messenger.
http://im.yahoo.com/

-------------------------------------------------------------------
Pitch in!  Send your pledge of support!  mailto:support@vwtype3.org