[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [T3] fender beading
- To: "Type3 List" <type3@vwtype3.org>
- Subject: RE: [T3] fender beading
- From: "eric" <Thorkhild@home.com>
- Date: Tue, 12 Sep 2000 22:37:56 -0400
- Importance: Normal
- In-reply-to: <016201c01d11$1aa14500$f24e08c3@dad2>
- Resent-date: Tue, 12 Sep 2000 22:39:05 -0400
- Resent-from: type3@vwtype3.org
- Resent-message-id: <"SePz21.0.dd1.6Zklv"@maria.yourwebhost.com>
- Resent-sender: type3-request@vwtype3.org
Anyone try using the vinyl kind. I haven't yet but I'm looking into it. from
what I've seen so far I think it might work. Not to mention the mass amount
of available colors!
-----Original Message-----
From: Dave Hall [mailto:dave@hallvw.clara.net]
Sent: Tuesday, September 12, 2000 7:21 PM
To: Type III
Subject: Re: [T3] fender beading
> If you look over your car you will see that the beading varies in
> cross section shape. I wonder how they did this. It looks like they
> may have started with beetle beading and then heat pressed it into
> type 3 shape.
It's all separate extrusions, Jim. They are heat welded at the change in
section. Even the rear fenders are handed, but it's not obvious until you
take a look or try fitting it the wrong side.
Dave.
UK VW Type 3 & 4 Club
http://www.hallvw.clara.co.uk/
------
-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe