Re: swingaxle / torsion rods / wheel alignment???

["Tom Hansen" <DrSoWatt@worldnet.att.net>]

I think everybody else had the right coaxing, but I have two questions. Did
you mark the axles to the spring plate B4 you unbolted them and did you put
it back together and matched the marks(this also applies to the trans
mounts, remember the slots?)? Or was the trans a complete swap including
axles?

If its yes to the 1st question you should be aligned or d##n close. If yes
to the 2nd, you should have the car aligned by a competent ( read "Air
Cooled Knowledgeable") shop, not Midas or the like.

hope this helps
Later, Tom

-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe