[T3] lowering rear end

[SNAPHENGER@aol.com]

I just lowerd the rearend of my 66 fasty swing axle.  i had to use a combo of 
inner spline rotation and outer. I came up with an adjusted spring plate 
angle of 15 degrees.  My haynes manual says 20degrees is stock. I had lowerd 
it to 10 degrees but way too low, I had to rotate outside spline 3 splines to 
come up with this. I have not finished the car yet, but was wondering if this 
sounded right . I have been following the list on the caster camber chat. I 
have lowered the front two splines so I wanted it to look good. slite rake is 
good.  any comments would help.
thanks
Dave 66 fasty

-------------------------------------------------------------------
List info at http://www.vwtype3.org/list or mailto:help@vwtype3.org