[T3] Yet another dizzy question

[Per Lindgren <lindgre@online.no>]

I've removed teh dizzy in my 73 today to replace points and capacitor.
So when I had it on the table, I quickly found that I should disassemble
the entire dizzy to clean, de-rust and lube. So when I removed the
points mounting plate, I found a small piece of wire soldered to the
bottom half. Where does the other end go, is it soldered to the other
plate or to the housing? I couldnt find this in any of my manuals, nor
the archive. Any answers welcome, as always.

Oh, this is the single point, vacuum dual carb dizzy.

PerL
73 Variant L

-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe