[T3] FI clips and update...

[Jon <afn01446@afn.org>]

Does anyone know where the FI plastic plug clips for a 71 T3
can be found? The wiring harness has problems somewhere, as
every now and then the engine just "dies" for a split second,
then kicks back in. I'm 99% certain that it is a wiring issue,
but it never happens when any of the ECU power wires have the
meter on them. :(

The tie rod ends were just replaced and two new front tires
were put on. The front end is much better, only a slight
vibration on the LF wheel.  The spindle nut was slightly loose
and allowed the rotor about an 1/8th inch of play on the outer
bearing.  It's been tightened and will be driven later to check
it.

The FI systems seems a bit weak, idles at around 1100rpm, and
runs a fuel pressure of anywhere between 31 and 42psi. 
The weakness is something I havent had time to read up on, the idling is something I havent adjusted
yet, but the fuel
pressure bothers me.  I'll have to read up on that later
to see what all I should check, and how.

Thanks for your time, and patience.. :)
Jon

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe