[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Doh! The first sentence is wrong. I made the correction below! >-----Original Message----- >Taking what Per wrote and analyzing the CB Performance descriptions the >measurement is taken along the width. > >If this was a gear sitting in front of you with it's axis in >the vertical >plane (on a 21" monitor the image is close to actual size :) -- > > __________ > | *| * I * | W > | *| * I * | i > | *| * I * | d > ------------ t > Length h > > >| = Tooth peak >* = Valley between teeth > >The gear I have is *about* 22mm in width. Must be stock... > >Thanks volks! > Toby Erkson > air_cooled_nut@pobox.com > (This is my preferred address) > >>-----Original Message----- >>> Where does one measure to figure out the size of their pump? I'm >>> remembering the 28mm or 30mm sizes coming to mind but don't >quite know >>> where this measurement is taken. >> >>My memory tells me its the width of the gears, measured along >>the teeth. >>Wouldn't you believe it, Tom Wilson says the same thing in his book! > >------------------------------------------------------------------- >Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe >