[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
The sleeve for the later throwout bearing. It was fitted from 1971 over here, and fits on three studs over the gearbox input shaft seal. Maybe it's called something different in the USA? Dave. UK VW Type 3&4 Club http://www.hallvw.clara.net/ -----Original Message----- From: Jim Adney <jadney@vwtype3.org> To: type3@vwtype3.org <type3@vwtype3.org> Date: 18 May 1999 03:47 Subject: Re: [T3] Power of the T3... On 17 May 99, at 20:12, Dave Hall wrote: > I > did the Variant (Square) clutch at the weekend and broke a clutch bolt. Strange, I never broke one of these, either. You really wouldn't expect to have a problem when removing them. > there were quite > a few bits of old lining in the bell housing debris, but it's not off the > present lining and the car has only done 67,000 miles. The sleeve had > been replaced with a black (plastic?) one. Maybe there had been some > catastrophic breakage in the past. What sleeve? Jim - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- List info at http://www.vwtype3.org/list or mailto:help@vwtype3.org