T3: Re: Fuel injector seals

[Jake Kooser <jake_k@ibm.net>]

Yeah, Buddy!  There are supposed to be two seal per injector.  One of
them goes just under the metal retainer plate that holds the injectors
in place.  The other one goes into the little hole in the end casting
(manifold) and the tip of the injector slips into it.  Make sure the
seals at the end casting aren't there before you go nuts, I've seen them
make the injectors hard to get in because they block the injector from
sliding right in.  RMMW has a full set of seals for around $8.00 if I
recall correctly.

Jake Kooser