[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 10 Nov 97, Richard H. Overman wrote:
> Hi, fellow Type 111ers!
> Today I am looking for those little clips with round, flat heads
> that
> go clear through the panels located in the cargo area for my '63.
> These are NOT the ones that you can get for door & quarter panels.
> In profile they look like a T and the vertical part of the T has
> expansion bits on it to keep it in the hole.
>From 68 and later use the same clips everywhere. These are the ones
available from WCM. I didn't realize that early cars used a
different clip in some places. Is it possible that someone has
changed these?
> I'm also still looking for a source for the OEM rear window seal
> for a
> Squareback, the one with that takes the moulding strip.
I probably have a good used one.
> Also on my wish list is some new gaskets for the fresh air/rain
> drain
> intakes under the dash. I finally figured out where all the water
> was getting in: bad gaskets and rust. I haven't seen any in my
> catalogs, so all clues would be helpful.
Hardware stores around here have a number of sizes of clear hose in a
variety of sizes. Perhaps you could just buy several feet of
something appropriate and cut to length.
Jim
---------------------------------------------------------------------
Melissa Kepner Jim Adney
Laura Kepner-Adney
jadney@vwtype3.org
Madison, Wisconsin
---------------------------------------------------------------------